The 8ft (2.4m) concrete intermediate fence post is the straight-run post in a slotted panel-fencing system. Its 100 x 100mm profile accepts fencing from opposite sides, allowing one bay to continue directly into the next while the post keeps the run aligned.
Intermediate posts are repeated throughout a run, so consistency matters more than on any other post type. Keep section orientation, slot alignment and top level under control as each bay is installed.
The 2.4m post combines wet-cast concrete and internal steel reinforcement. After casting it is vibration finished for three smooth sides out of four, with a pyramid profile at the top. Concrete remains unaffected by timber-style ground-line rot, which makes it a practical material for a post intended to stay fixed in the ground. Inside the slot is a shoulder positioned around 600mm from the bottom. This is designed to support a concrete gravel board, helping create a consistent base and keeping the timber panel above away from direct ground contact. That support detail is useful when compatible concrete gravel boards form the base of the fence, because the board can sit at a consistent level beneath the panel.
Set the straight run from a string line and measure centres from the actual panel or gravel-board width so small spacing errors do not accumulate over several bays. Keep the post plumb while the setting material cures. The fence post length calculator can help compare post lengths before digging, and an appropriate cement product should be used for the chosen ground-fixing method. Because the post is 2.4m long, plan handling and temporary bracing before installation, especially where access to the hole is restricted by an existing fence or planting.
The 8ft intermediate post is a versatile size for substantial straight panel runs because 2.4m overall gives useful scope for both visible height and below-ground fixing. It is often the size to compare when shorter posts feel marginal, while the 9ft version remains available where the site genuinely needs more length. Choose an intermediate post only for a straight section of the boundary. Where the fence changes direction, ends, or splits into three runs, use the corresponding corner, end or 3-way post so the slots face the correct directions.
For a complete slotted system, match this 8ft component with the correct profiles from the concrete fence posts range. Check every corner, end and junction on the plan before ordering so the 2.4m posts arrive in the right slot configurations.
